Chapter 13

1. What percentage of finished foam is water?

2. Clearance between the bottom of the extinguisher and the floor should never be less than:

3. How are portable fire extinguishers classified?

4. What is the biggest disadvantage to dry-chemical systems?

5. Which type of clean system agent is no longer produced but may still be in service?

6. Which foam expansion rate is useful as a space-filling agent?

7. Which fire extinguisher agent is subject to freezing if not kept in a heated area or an antifreeze agent added?

8. Which foam expansion rate is used primarily to extinguish fires involving liquid fuels?

9. The four elements necessary to produce high-quality fire fighting foam include foam concentrate, water, mechanical agitation, and:

10. The general category of fire extinguishing agents that effectively leaves no residue is a:

11. Which foam proportioner allows for automatic proportioning over a wide range of flows and pressures and does not depend on an external power source?

12. Which of the following tasks regarding dry-chemical systems is an Inspector I MOST likely to be required to perform?

13. What is critical to total flooding applications of carbon dioxide (CO2) systems in order for them to be effective?

14. Which class of fire involves energized electrical equipment?

15. How are special-agent fire extinguishing systems classified?

16. The special-agent fire extinguishing system most effective on fires in commercial cooking equipment that produces grease-laden vapors is a:

17. Which fire extinguisher agent extinguishes primarily through a smothering action?

18. When rapid fire extinguishment is required and reignition is unlikely:

19. Which type of foam fire extinguishing system is wheel mounted and may have a water supply connection capability?

20. What is the greatest concern for extinguisher reliability?

21. Which type of fire extinguisher stores expellant gas and extinguishing agent in a single chamber?

22. Which dry-chemical system component releases agent into the piping system?

23. The system used when water alone may not be an effective fire extinguishing agent is a:

24. Which type of dry powder agent is sodium chloride (salt) based?

25. Which type of foam system method extinguishes a fire by intervening between the fuel and the fire?

26. Which type of dry-chemical fixed application method introduces a concentration of agent into a closed area?

27. Wet-chemical fire extinguishing agents are delivered to the hazard area in the form of a:

28. What is required for a special-agent extinguishing system to be considered successful?

29. The stage of foam formation that mixes water with foam liquid concentrate is:

30. Which foam proportioner is the most common type of built-in proportioner installed in mobile fire apparatus?